Eliminate your wheel hop and improve your 60 foot times at the track without removing the rear valance panel! Shown here is all of the hardware and components needed to install your differential brace.
All that is required for the Track Hawk are the four bolts shown and two nuts to attach it to on the inside of the cross member. You will have to drill a hole in your cross member with the provided drill bit and instructions. Installation takes approximately 25 minutes.
Fits Trackhawk and Jeep SRT.
| Select Finish | Raw, Anodized Black, Anodized Red, Anodized Blue, Anodized Purple, Anodized Gold |
|---|
Related products
Out of stock
$1,912.48
-
Out of stock
$1,074.98
-
Out of stock
$1,074.98
-
